This site requires javascript and cookie operation.

ATEM interlaced mode

enabling ATEM TVS interlaced recording / streaming mode

This can be achieved when the internal hardware resampler is not activated by either MX Light or the ATEM TVS control panel.

Prepare MX Light for interlaced recording with the following steps:

  • Load MX Light
  • Click the small 'R' button on the Inp/Enc > Resampling tab (bottom-right)
  • Un-check 'USPS' on the Inp/Enc > Resampling tab (bottom-right)
  • Un-check 'Auto 'test /set' encoder on start' on the General > startup tab
  • Click save button
  • Close MX Light
  • Power off PC then ATEM Television Studio
  • Power on ATEM Television Studio then PC
  • Load MX Light
  • In ATEM Control panel, change TVS video input setting from 1920 x 1080 50i >> 1920 x 1080 59.94i
  • In MX Light click 'check' on the Inp/Enc page
  • In ATEM Control panel, change TVS video input setting from 1920 x 1080 59.94i >> 1920 x 1080 50i